The Paragon MagicFuse Microwave kiln

Paragon MagicFuse Microwave Kiln

Paragon’s exciting MagicFuse kiln fires inside a microwave oven to glass fusing temperatures. This is the perfect way to introduce yourself and your loved ones to the amazing world of glass fused jewelry. Create stunning jewelry that your family and friends will treasure. Experiment with the huge selection of stained glass colors available from your local glass supplier.

Instant gratification

Place the kiln inside a microwave oven and turn on the power. The kiln will reach 1500°F (815°C) in about 5 - 8 minutes. (Firing time depends on the wattage and brand of the microwave oven.)

Beautiful colors

Create beautiful glass fused pendants and earrings. Discover how the heat magically transforms glistening dichroic glass and a wide variety of stained glass colors. Enjoy hours of creative entertainment with your whole family.

Within an hour after you begin fusing, the glass will be cool to the touch. Experiment with new designs in the MagicFuse before filling your larger kiln with production loads.

Learning to fuse glass

Firing the MagicFuse requires skill. Because the kiln fires so rapidly, glass pieces should be limited in size to 2 layers of 1 ½” x 1 ½” or smaller. Larger sizes or additional layers of glass must be pre-heated for 5 minutes at a 50% power setting on the microwave. Otherwise the glass will break.

Annealing in a separate kiln is unnecessary for small glass pieces such as earrings and small pendants. The glass must also be free of glue, grease, and fingerprints. The rapid firing of these contaminants can cause the glass to break.

Firing times may vary even within the same microwave oven. The firing time varies from one microwave to the next, and a MagicFuse kiln that is still warm from a previous firing takes less time to fire than a cold kiln. For these reasons, visually check the glass a minute or two before it is done. Then fire longer and check it again. Remove the kiln when the glass has fused just the way you had envisioned. The glass begins to fuse during the last 30 seconds of firing. This is why precise fusing is much easier by visually inspecting the glass.

The microwave oven

The MagicFuse requires a microwave oven, which is not included. The voltage, watts, and amps shown in the specifications below are for a typical 1100 watt microwave oven. Since the MagicFuse does not contain heating elements, the electrical specs will vary depending on the microwave you own and the country where you live.

If you remove the MagicFuse kiln after the glass has fused, the heat will not build up inside the microwave oven. The MagicFuse reaches higher temperatures than you will ever encounter in your kitchen. But the firing is so rapid that the heat does not have time to work its way to the outside surface of the kiln.

You can fire the MagicFuse in the same microwave oven you use for cooking as long as you clean the microwave oven after each fusing session. If, however, you fire ceramic fiber paper, you might want to fire glass in a separate oven. This is because the fiber paper produces fumes.

Controlling heat distribution

Firing the MagicFuse kiln on the microwave's food rotator tray produces better heat distribution inside the kiln than firing without the tray. However, in some microwaves the rotator tray jerks as it turns, moving glass pieces out of position. If this is a problem with your microwave, either use a different microwave, or remove the rotator tray and rollers from the microwave. If you cannot remove the rotator parts, then turn the rotator tray upside-down, and place 3 of the ½" ceramic posts that came with your kiln on the tray.

Accessories included with the kiln

Includes 6 - ½” ceramic posts, glass separator, and a 15-page 5 1/2” x 8 1/2” instruction manual.

Specifications